How to use the pipe bender:

1. How to use:

(1) Refer to the instruction manual of the electric oil pump.

(2) First screw the working oil cylinder into the internal thread of the square block, so that the rear end of the oil cylinder is mounted on the wheel of the bracket downward.

(3) Select the die head according to the outer diameter of the pipe to be bent, set it on the plunger, place the corresponding grooves of the two rollers toward the die head, and then put it into the corresponding size flower plate hole, and then cover the upper flower plate , Insert the elbow pipe into the groove, then pull back the movable part of the quick connector at the end of the high-pressure oil pipe and put it on the joint of the working oil cylinder, and tighten the oil drain screw on the electric oil pump to bend the pipe . After bending the pipe, loosen the oil drain screw and the plunger will automatically reset.

2. Matters needing attention:

(1) Refer to the instruction manual of the electric oil pump.

(2) Never remove the quick connector when there is a load.

(3) This machine uses oil as the medium. Do a good job in cleaning and maintenance of the oil and the machine to avoid blockage or oil leakage, which will affect the effect of use.